Skip to content
AnyRecalls

1989 Acura Legend recalls

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

2 recalls found in NHTSA data as of September 22, 2026

For the 1989 Acura Legend. These apply to the model and year, not to one particular vehicle: check your VIN to see whether yours is included and whether it has been repaired.

Has your Acura been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. Recall repairs are free.

1989 Acura Legend recalls, newest first

May 24, 1995NHTSA 95V1030013,700,000 vehicles potentially affected

Seat belts › Front › Buckle assembly

Summary
The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
Consequence
The safety belts would not provide adequate protection to an occupant in a vehicle crash.
Remedy
Owners should promptly check the condition and operation of both front safety belt buckles. Carefully inspect the red release button for any breaks or cracks. Check that both buckles are operating properly by inserting each latch plate into its buckle, tug on the belt to make sure the latch is securely locked, then press the release button. The latch plate should pop out of the buckle when the button is pressed. If either release button shows any sign of breakage or cracking, or if either buckle fails to operate properly, promptly contact your authorized Honda/Acura dealer to schedule an appointment to have the buckle replaced or repaired, free of charge. The manufacturer is developing a remedy designed to prevent the failure of the buttons that are not currently broken.

This recall on nhtsa.gov

October 29, 1990NHTSA 90E04300336 vehicles potentially affected

Air bags › Frontal

  • Aftermarket equipment: applies only if this part was installed
Summary
Threaded inflator components may have been damaged during assembly which may allow components to separate when inflator receives a signal to deploy the air bag.
Consequence
Inflator component separation allows hot combustion gases to escape into the passenger compartment which could result in injuries to vehicle occupants.
Remedy
Replace air bag modules containing potentially defective inflators.

This recall on nhtsa.gov

Owner complaints

Owners have filed 34 complaints about the 1989 Acura Legend with NHTSA. Complaints are unverified reports from the public; NHTSA uses them to decide what to investigate.

Crashes reported
6
Fires reported
1
Injuries reported
5
Deaths reported
0

Most complained-about components

  1. Service brakes12
  2. Hydraulic › Antilock/traction control/electronic limited slip8
  3. Air bags › Frontal7
  4. Seat belts › Front › Buckle assembly3
  5. Vehicle speed control3

Other Acura Legend years

Other 1989 Acura models

Questions

Does the 1989 Acura Legend have any recalls?
2 recalls found in NHTSA data as of September 22, 2026, covering: seat belts, air bags. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.
How do I check if my 1989 Acura Legend recall has been fixed?
Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Acura dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.
How many complaints have owners filed about the 1989 Acura Legend?
34 complaints filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.