Skip to content
AnyRecalls

1988 Chevrolet Beretta recalls

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

5 recalls found in NHTSA data as of September 22, 2026

For the 1988 Chevrolet Beretta. These apply to the model and year, not to one particular vehicle: check your VIN to see whether yours is included and whether it has been repaired.

Has your Chevrolet been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Chevrolet dealer can also check your VIN. Recall repairs are free.

1988 Chevrolet Beretta recalls, newest first

May 19, 2006NHTSA 06E04300088,303 vehicles potentially affected

Fuel system, gasoline

  • Aftermarket equipment: applies only if this part was installed
Summary
Certain replacement fuel filters, fram brand name p/n G3727, with date codes X52911 through X60801 sequentially or X600141 and a mexico country or origin marking on the fuel filter housing manufactured from October 18, 2005, through March 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on "document search" and then "bus applications"). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.
Consequence
This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.
Remedy
Honeywell will notify owners and replace the fuel filters free of charge. The recall began on October 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).

This recall on nhtsa.gov

November 26, 1991NHTSA 91V206000722,884 vehicles potentially affected

Seat belts

Summary
The front shoulder belt retractors may have reduced sensitivity of the lock-up feature and would not function in a sudden deceleration or crash.
Consequence
Failure of the shoulder belt retractor would result inthe seat occupant only being restrained by the lap belt in a crash or suddenstop, and an increased possibility of injury.

This recall on nhtsa.gov

August 19, 1991NHTSA 91V135000290,408 vehicles potentially affected

Structure › Body › Hood

Summary
Secondary hood latch assembly on these vehicles may not be properly adjusted and could become bent. This will lead to a condition where full primary latch engagement is not attained.
Consequence
A bent secondary hood latch could lead to the primarylatch not being fully engaged, allowing the hood to unexpectedly open. If thiswere to occur while the vehicle was in motion, the hood may contact thewindshield, reducing the forward vision area of the driver and a vehicle crashcould occur without prior warning.
Remedy
Replace the primary hood latch assembly, the secondary hood latch assembly, and the support bracket.

This recall on nhtsa.gov

December 18, 1989NHTSA 89V225000170,769 vehicles potentially affected

Structure › Body › Door › Hinge and attachments

Summary
A door hinge (upper or lower) may break while opening or closing the door making it difficult to reposition and close properly.
Consequence
Hinge separation may reduce the structural integrity ofthe side of the car and increase risk of injury in certain types of accidents.
Remedy
Replace door hinges on both doors.

This recall on nhtsa.gov

March 23, 1988NHTSA 88V039000282,052 vehicles potentially affected

Latches/locks/linkages › Hood › Latch

Summary
Secondary hood latch assembly may not have been properly adjusted resulting in latch becoming bent.
Consequence
A bent secondary hood latch could cause the primarylatch to malfunction. If this occured the hood could unexpectedly open. Ifthis happened while vehicle is in motion reduction of forward visibility couldcause a vehicle crash without prior warning.
Remedy
Inspect and replace secondary hood latch assemblies as required.

This recall on nhtsa.gov

Owner complaints

Owners have filed 60 complaints about the 1988 Chevrolet Beretta with NHTSA. Complaints are unverified reports from the public; NHTSA uses them to decide what to investigate.

Crashes reported
3
Fires reported
4
Injuries reported
5
Deaths reported
1

Most complained-about components

  1. Service brakes9
  2. Structure › Body › Door › Hinge and attachments9
  3. Electrical system › Wiring › Interior/under dash5
  4. Latches/locks/linkages › Hood › Latch5
  5. Engine and engine cooling › Engine › Gasoline4

Other Chevrolet Beretta years

Other 1988 Chevrolet models

Questions

Does the 1988 Chevrolet Beretta have any recalls?
5 recalls found in NHTSA data as of September 22, 2026, covering: fuel system, gasoline, seat belts, structure, latches/locks/linkages. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.
How do I check if my 1988 Chevrolet Beretta recall has been fixed?
Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Chevrolet dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.
How many complaints have owners filed about the 1988 Chevrolet Beretta?
60 complaints filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.