Does the 1983 Oldsmobile Firenza have any recalls?

5 recalls found in NHTSA data as of September 22, 2026, covering: fuel system, gasoline, engine and engine cooling, seats, service brakes, hydraulic. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.

How do I check if my 1983 Oldsmobile Firenza recall has been fixed?

Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Oldsmobile dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.

How many complaints have owners filed about the 1983 Oldsmobile Firenza?

0 complaints filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.

1983 Oldsmobile Firenza recalls

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

5 recalls found in NHTSA data as of September 22, 2026

For the 1983 Oldsmobile Firenza. These apply to the model and year, not to one particular vehicle: check your VIN to see whether yours is included and whether it has been repaired.

Has your Oldsmobile been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

Check your VIN with NHTSA

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Oldsmobile dealer can also check your VIN. Recall repairs are free.

1983 Oldsmobile Firenza recalls, newest first

May 19, 2006NHTSA 06E04300088,303 vehicles potentially affected

Fuel system, gasoline

Aftermarket equipment: applies only if this part was installed

Summary: Certain replacement fuel filters, fram brand name p/n G3727, with date codes X52911 through X60801 sequentially or X600141 and a mexico country or origin marking on the fuel filter housing manufactured from October 18, 2005, through March 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on "document search" and then "bus applications"). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.
Consequence: This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.
Remedy: Honeywell will notify owners and replace the fuel filters free of charge. The recall began on October 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).

This recall on nhtsa.gov

October 26, 1987NHTSA 87V165000126,319 vehicles potentially affected

Engine and engine cooling › Exhaust system › Emission control › Crankcase (pcv)

Summary: Internal corrosion of pulsair check valve assembly could permit exhaust gas to melt the plastic shut off valve and draw valve pieces into the air cleaner and throttle body.
Consequence: If valve pieces lodge against throttle plate, engine maynot return to idle resulting in loss accelerator control and possibly a crash.
Remedy: Replace pulsair check valve and shut off valve with newly designed valves.

This recall on nhtsa.gov

May 7, 1987NHTSA 87V0790001,136,407 vehicles potentially affected

Seats

Summary: The metal floor pan anchor bar could fatigue and break around the left front outer seat adjuster stud of the drivers seat, allowing the stud to separate from the floor pan anchor bar.
Consequence: Drivers seat could tip rearward unexpectedly; this couldresult in loss of control and a vehicle crash without prior warning.
Remedy: Install a reinforcement bracket on the floor pan anchor bar at the left front outer seat adjuster position of the drivers seat.

This recall on nhtsa.gov

October 13, 1983NHTSA 83V105000352,036 vehicles potentially affected

Service brakes, hydraulic › Foundation components › Differential proportional valve

Summary: The brake proportioner valves may break and separate from the master cylinder. This would allow brake fluid to leak and would result in a partial loss of the brake system.
Remedy: The dealer will inspect and, if necessary, replace all suspect valves.

This recall on nhtsa.gov

October 7, 1982NHTSA 82V09600012,721 vehicles potentially affected

Fuel system, gasoline › Fuel injection system › Injectors

Summary: Possible fuel leakage could occur at the throttle body injection fuel feed pipe connection on the involved vehicles.
Remedy: The fuel feed line fitting bolt and two washers will be replaced by the dealer at no cost to owner.

This recall on nhtsa.gov

Owner complaints

No owner complaints about the 1983 Oldsmobile Firenza were found in NHTSA’s complaint data.

Other Oldsmobile Firenza years

Other 1983 Oldsmobile models

Questions

Does the 1983 Oldsmobile Firenza have any recalls?: 5 recalls found in NHTSA data as of September 22, 2026, covering: fuel system, gasoline, engine and engine cooling, seats, service brakes, hydraulic. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.
How do I check if my 1983 Oldsmobile Firenza recall has been fixed?: Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Oldsmobile dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.
How many complaints have owners filed about the 1983 Oldsmobile Firenza?: 0 complaints filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.