Skip to content
AnyRecalls

Vehicle recall 08V190000 · April 25, 2008

Kenworth C500, T2000 and 3 more models

Certain trailer cable mounting brackets have a 'u-shaped' cut out that only partially supports the trailer cable connection.

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

Summary
Paccar is recalling 3,573 my 2007 kenworth C500, T800, T600, T2000, and W900 chassis built with phillips qcs II trailer cable connection and trailer cable mounting bracket with 'u-shaped' cut out. Certain trailer cable mounting brackets have a 'u-shaped' cut out that only partially supports the trailer cable connection. Partial support of the cable connection may allow the molded boot and electrical ground pin to partially or completely pull away from the 7-way socket. Partial or complete detachment of the cable connection can cause reduced water resistance and potential loss of electrical ground. There is also a possibility the trailer lights may fail to illuminate without the operator's knowledge.
Consequence
If this condition were to occur, other motorists may not be warned of the tractor/trailer movements, increasing the risk of a crash.
Remedy
Dealers will install a reinforcement bracket between the flexible back of the qcs II molded boot and the frame bracket, and reattach the supporting bolts. The recall began on may may 30, 2008. Owners may contact kenworth at 1-425-828-5440.
Notes
Kenworth recall no. 08KW6.CUSTOMERS may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (TTY: 1-800-424-9153); or go to http://www.safercar.gov.

Recall details

NHTSA campaign
08V190000
Reported to NHTSA
April 25, 2008
Filed by
PACCAR INCORPORATED
Manufacturer campaign
08KW6
Owner notification
May 30, 2008
Vehicles potentially affected
3,573
Initiated by
NHTSA’s Office of Defects Investigation
Components
Trailer hitches › Fifth wheel assembly
Recall 08V190000 on nhtsa.gov, with the manufacturer’s documents

Vehicles covered

As listed by NHTSA. A recall usually covers only some vehicles of each model and year, often a production date range.

Has your Kenworth been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Kenworth dealer can also check your VIN. Recall repairs are free.