Kenworth T2000 recalls by year
Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.
46 recalls found for the Kenworth T2000 in NHTSA data as of September 22, 2026, and 38 owner complaints. Choose a model year:
Has your Kenworth been repaired?
Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.
NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Kenworth dealer can also check your VIN. Recall repairs are free.
Newest Kenworth T2000 recalls
- Mar 24, 201111V203000Engine and engine cooling5,831 vehiclesKenworth C500, Kenworth T2000 and 4 more models
Degradation of a combustion tube weld can cause radial heat impingement on the body which may burn through certain bodies used on C15 engines.
- Feb 23, 201111V127000Fuel system, other4,664 vehiclesPeterbilt 384, Peterbilt 386 and 13 more models
The oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil…
- Dec 13, 201010V634000Power train12,873 vehiclesPeterbilt 357, Peterbilt 378 and 11 more models
The bearing surfaces of the extended lube universal joint that attaches the inter-axle driveline to the drive axle may become prematurely worn due to breakdown of lubrication…
- Jul 2, 201010V308000Steering9,697 vehiclesPeterbilt 365, Peterbilt 367 and 10 more models
The circumferential weld around the steering shaft tube that welds the splined tube to the non-splined tube may be mislocated.
- May 4, 201010V185000Suspension21 vehiclesKenworth T2000, T660 and 2 more models
The rear axle outer end hub may have not been primed with oil properly during the rear axle installation process.
- Dec 23, 200909V490000Steering3,078 vehiclesKenworth T2000, T660 and 2 more models
The fasteners attaching the steering gear to the front drive bracket may have received insufficient torque during the installation process resulting in less than required clamp…
- Oct 21, 200909V415000Power train914 vehiclesKenworth T2000, T660 and 2 more models
The axle u-bolts attaching the axle to the suspension leaf spring on certain AG400L rear suspensions may have received insufficient fastener torque during the installation process.
- Jul 8, 200909V258000Steering2,096 vehiclesPeterbilt 365, Peterbilt 367 and 9 more models
Mislocation of a circumferential weld may allow the splined tube and non-splined tube to rotate relative to one another during a low speed, high torque turn, possibly resulting…