1995 Ford Windstar recalls

Vehicle speed control

Summary

Ford is recalling model years 1995-2003 windstar, 2000-2003 excursion diesel, 1993-1997 and 1999-2003 F-250 sd through F-550 sd diesel, 1992-2003 E-150 through E-550, 1995-2002 explorer, 1997 and 2002 Mercury mountaineer, 1995-1997 and 2001-2003 ranger, and 1994 F53 vehicles equipped with the texas instruments speed control deactivation switch (scds). The scds may leak internally and then overheat, smoke, or burn.

Consequence

A vehicle fire could occur with or without the engine running.

Remedy

Ford will notify owners that dealers will install a fused wiring harness in line with the scds. On 1999-2003 windstar vehicles with a leaking scds, dealers will also inspect the ABS control module connector and repair as necessary. Repairs will be completed free of charge. The safety recall began on October 27, 2009. Owners may contact Ford at 1-888-222-2751.

This recall on nhtsa.gov

Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings

Summary

On certain minivans originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia. During assembly, some brake lines were installed in a twisted position, causing contact with the dash panel insulator above the catalytic converter. This contact could abrade the brake line corrosion protection, consequently, salt or water absorbed in the dash panel insulator would promote corrosion. This corrosion could ultimately lead to a leak in the brake line.

Consequence

Leakage of brake fluid will result in brake light activation. Extended stopping distance could also result, increasing the risk of a crash.

Remedy

Dealers will inspect the brake line for corrosion and clearance conditions. A brake line that is not corroded will be repositioned. A brake line that is corroded or leaking will be replaced with a nylon coated brake line and secured using three retaining clips to assure clearance from the insulator. Owner notification began may 10, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Ford at 1-866-436-7332.

This recall on nhtsa.gov

Fuel system, gasoline › Storage › Tank assembly

Summary

Vehicle description: minivans which were originally sold or currently registered in the following hot weather states: alabama, arizona, arkansas, california (10 southern counties), florida, georgia, hawaii, louisiana, mississippi, nevada (clark county only), oklahoma, south carolina and texas, can develop cracks in the fuel tank in the forward strap area of the standard 20 gallon tank due to a combination of factors that are present in certain very hot areas of the country.

Consequence

These cracks could result in fuel leakage if they propagate through the wall of the tank.

Remedy

Dealers will install a brace assembly at the strap bolt hole location and replace the tank strap with a revised, longer strap. Dealers will also inspect the tanks for leaks. If a leak exists and is the result of a crack in the fuel tank, the tank will be replaced in addition to the installation of a spacer and longer strap.

This recall on nhtsa.gov

Structure › Body › Hood

Summary

Vehicle description: passenger vehicles and mini vans. Tearing of the bond between the inner and outer hood panels during minor front end collisions can result in a gap at the leading edge of the hood. Air forced between the inner and outer panels can produce enough pressure to force the outer panel upward.

Consequence

This condition can result in total separation of the outer hood panel.

Remedy

Dealers will inspect the hood area for any damage along the leading edge of the hood. If there is any evidence of bond separation, the hood will be replaced. If there is no evidence of bond separation, additional adhesive will be applied between the inner and outer hood panels.

This recall on nhtsa.gov

Air bags › Frontal

• Aftermarket equipment: applies only if this part was installed

Summary

The passenger side air bag has an inflator body that cracked during forming of the curl that retains the igniter plug in the end of the inflator. Also the igniter end cap can separate from the inflator.

Consequence

The passenger side air bag may not inflate properly resulting in reduced occupant protection in a vehicle accident. If the igniter end cap separates in a frontal collision, hot gases can be released and ignite flammable material or cause burn injuries.

Remedy

Dealers will remove and replace the passenger side air bag module.

This recall on nhtsa.gov

Electrical system › Alternator/generator/regulator

Summary

The alternator output wire was not connected tightly to the power distribution box.

Consequence

This can result in overheating of the connection and a possible vehicle fire.

Remedy

Dealers will inspect and tighten the connection. Vehicles with visible damage to the plastic power distribution box housing will have the the underhood harness, including the power distribution box, replaced.

This recall on nhtsa.gov

Electrical system › Wiring › Front underhood

Summary

The wiring harness insulation can abrade on a brace that runs from the instrument panel to the cowl.

Consequence

This condition can result in an electrical short and possibly a vehicle fire.

Remedy

Dealers will install a shield on the instrument panel to cowl brace, and installation of a piece of convolute wrap material on one of the adjacent harnesses.

This recall on nhtsa.gov