Skip to content
AnyRecalls

1984 Freightliner Conventional recalls

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

4 recalls found in NHTSA data as of September 22, 2026

For the 1984 Freightliner Conventional. These apply to the model and year, not to one particular vehicle: check your VIN to see whether yours is included and whether it has been repaired.

Has your Freightliner been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Freightliner dealer can also check your VIN. Recall repairs are free.

1984 Freightliner Conventional recalls, newest first

October 11, 1988NHTSA 88V16000092 vehicles potentially affected

Steering › Linkages

Summary
Steering arm may fail if used on eaton EFA12F4 from axle in conjunction with ross HFB70 power steering gear.
Consequence
A failed steering gear arm could lead to loss of vehiclecontrol and vehicle crash.
Remedy
Install a nonadjustable 1500 PSI power steering pump pressure relief valve to limit steering arm forces. Replace steering arm with a design capable of withstanding higher forces. Adjust maximum poppet valve settings to 500 PSI and adjust axle stops.

This recall on nhtsa.gov

October 20, 1986NHTSA 86V137000102 vehicles potentially affected

Seat belts › Front › Retractor

Summary
Seat belts can loosen as the truck is driven. Consequence of defect: driver and passenger would not be properly restrained in event of a sudden stop or crash.
Remedy
Replace the non locking retractor seat belts with automatic locking retractor seat belts.

This recall on nhtsa.gov

August 26, 1986NHTSA 86V1180006,800 vehicles potentially affected

Structure › Body

Summary
The handhold mounting system, which consists of a tubular handle held in three places by cast aluminum brackets and attached to the engine exhaust muffler heat shield. Vibration from this system causes the handhold parts to wear. Consequence of defect: if the parts wear thin the possibility exists that the handhold might give way under the weight of a driver. This could result in personal injury.
Remedy
Replace the end brackets with a modified design utilizing a rubber isolater. Also, add a plastic sleeve to the center bracket for isolation.

This recall on nhtsa.gov

Owner complaints

Owners have filed 1 complaint about the 1984 Freightliner Conventional with NHTSA. Complaints are unverified reports from the public; NHTSA uses them to decide what to investigate.

Crashes reported
1
Fires reported
0
Injuries reported
2
Deaths reported
0

Most complained-about components

  1. Air1
  2. Service brakes1

Other Freightliner Conventional years

Other 1984 Freightliner models

Questions

Does the 1984 Freightliner Conventional have any recalls?
4 recalls found in NHTSA data as of September 22, 2026, covering: steering, seat belts, structure, latches/locks/linkages. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.
How do I check if my 1984 Freightliner Conventional recall has been fixed?
Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Freightliner dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.
How many complaints have owners filed about the 1984 Freightliner Conventional?
1 complaint filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.