Skip to content
AnyRecalls

1980 Chevrolet Malibu recalls

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

6 recalls found in NHTSA data as of September 22, 2026

For the 1980 Chevrolet Malibu. These apply to the model and year, not to one particular vehicle: check your VIN to see whether yours is included and whether it has been repaired.

Has your Chevrolet been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Chevrolet dealer can also check your VIN. Recall repairs are free.

1980 Chevrolet Malibu recalls, newest first

October 24, 2007NHTSA 07E088000121,680 vehicles potentially affected

Equipment

  • Aftermarket equipment: applies only if this part was installed
Summary
Certain honeywell fram racing brand HP4 and HP8 oil filters that were manufactured from may 25, 2006, through September 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code A61451 through A72571 sequentially. The date code and part number appear on the filter housing. Fram racing HP4 and HP8 oil filters not bearing a date code in this range are not affected by this recall. The gasket of the oil filter becomes more pliable under high temperatures and pressures.
Consequence
This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
Remedy
Honeywell will replace the affected oil filters free of charge. The recall began during November 2007. Owners can contact fram customer service toll-free at 1-800-890-2075.

This recall on nhtsa.gov

April 29, 1985NHTSA 85V0480001,810,000 vehicles potentially affected

Service brakes, hydraulic › Foundation components › Drum › Wheel cylinders

Summary
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: a loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
Remedy
Add a part to prevent wheel cylinder from rotating.

This recall on nhtsa.gov

November 24, 1984NHTSA 84V1490003,100,000 vehicles potentially affected

Power train › Axle assembly › Axle shaft

Summary
Rear axle assembly may have axles that were improperly manufactured. This condition may result in separation of the axle shaft and wheel assembly from the vehicle.
Remedy
The dealer will inspect the rear axle to determine whether it was manufactured at the buffalo plant. If so, they will make axle measurements and if necessary replace or modify affected axle components without charge.

This recall on nhtsa.gov

August 19, 1983NHTSA 83V07700019,108 vehicles potentially affected

Vehicle speed control › Cables

Summary
Accelerator pump lever retaining pin may loosen after repeated heavy accelerator pedal applications. This could cause the throttle to become stuck in the open position.
Remedy
Dealer will install a special cotter pin, to retain the accelerator pump pin, and a spring clip thrust washer on the accelerator pump link.

This recall on nhtsa.gov

February 25, 1981NHTSA 81V0250005,821,160 vehicles potentially affected

Suspension › Rear

Summary
The bolts that attach the lower rear control arm to the frame may fracture. The rear control arm supports and positions the rear axle. Fracture of the bolts would allow the control arm to drop free.
Remedy
Both rear control arm attachment bolts will be replaced without charge.

This recall on nhtsa.gov

February 11, 1981NHTSA 81V02200067,350 vehicles potentially affected

Visibility › Glass, side/rear

Summary
The electro-clear rear window defoggers contain a defect which causes the glass to shatter without impact during or some time after use of the defogger. Vertical electrical strips may deteriorate and cause hot spots that can result in breakage of the rear glass.
Remedy
Vehicles will be inspected for presence of a particular weatherstrip. If present, a layer of a special conductive epoxy will be added to the vertical bar on the rear window glass. This epoxy is a new conductive material which will not react with the weatherstrip.

This recall on nhtsa.gov

Owner complaints

Owners have filed 5 complaints about the 1980 Chevrolet Malibu with NHTSA. Complaints are unverified reports from the public; NHTSA uses them to decide what to investigate.

Crashes reported
0
Fires reported
1
Injuries reported
0
Deaths reported
0

Most complained-about components

  1. Fuel system2
  2. Gasoline › Storage › Tank assembly2
  3. Electrical system › Wiring › Front underhood1
  4. Tires › Sidewall1
  5. Tires › Temporary/emergency spare tire1

Other Chevrolet Malibu years

Other 1980 Chevrolet models

Questions

Does the 1980 Chevrolet Malibu have any recalls?
6 recalls found in NHTSA data as of September 22, 2026, covering: equipment, service brakes, hydraulic, power train, vehicle speed control, suspension, visibility. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.
How do I check if my 1980 Chevrolet Malibu recall has been fixed?
Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Chevrolet dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.
How many complaints have owners filed about the 1980 Chevrolet Malibu?
5 complaints filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.