1997 Ford Expedition recalls

Exterior lighting › Headlights

• Aftermarket equipment: applies only if this part was installed

Summary

Certain maxzone headlight assemblies, depo brand, p/nos. 331-1129L-asn and 331-1129R-asn, sold for use as aftermarket equipment for the above listed passenger vehicles. These headlamps fail to conform to the photometric requirements of federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

Consequence

Decreased lighting visibility may result in a vehicle crash.

Remedy

Maxzone will notify owners and offer reimbursement for any noncompliant headlights. The recall began on July 28, 2006. Owners may contact maxzone at 909-822-3288.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Certain aai motorsports combination lamps sold as replacement lamps for use on the above list passenger vehicles. Combination lamps not equipped with amber side reflectors fail to conform with the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment."

Consequence

Lack of amber side reflectors in the lamps will decrease lighting visibility to other drivers and may possibly result in a vehicle crash

Remedy

Aai motorsports will notify owners and replace the lamps free of charge. The recall began on August 1, 2006. Owners may contact aai motorsports at 909-923-9188.

This recall on nhtsa.gov

Vehicle speed control

Summary

On certain pickup trucks and sport utility vehicles equipped with speed control, the speed control deactivation switch may overheat, smoke, or burn.

Consequence

A fire at the switch could occur.

Remedy

By letter dated September 12, 2005, owners were instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected. Owners who have had their speed control deactivated are being notified that parts will be available and advised to make an appointment to reconnect the speed control beginning in February 2006. Owners who did not have their speed control deactivated are being notified to have their system remedied beginning in February 2006. Owners are urged to avail themselves of the free disconnect service as soon as possible because of the significant risk of fire. Owners may contact Ford at 1-800-392-3673. (note: also see recalls 05V017 and 06V286)

This recall on nhtsa.gov

Steering › Gear box › Shaft sector

Summary

On certain pickup trucks and sport utility vehicles, if the intermediate shaft yoke separates from the steering gear input shaft, the steering system becomes disconnected.

Consequence

This could result in loss of steering control, potentially resulting in a vehicle crash without warning.

Remedy

Dealers will inspect the steering intermediate shaft yoke to determine if the yoke is fully seated on the steering gear input shaft. If the yoke is fully seated no service is required. If the yoke is not fully seated and bolt groove and spline is visible, the intermediate shaft and bolt will be replaced as well as the bolt at the steering column connection. Owner notification began on may 30, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Ford at 1-800-392-3673.

This recall on nhtsa.gov

Exterior lighting

Summary

Vehicle description: mini vans, light pickup trucks, and sport utility vehicles. Off lease canadian vehicles equipped with daytime running lights which meet canadian requirements and not the photometric requirements of FMVSS 108, "lamps, reflective devices, and associated equipment." according to Ford, the vehicles were imported into the U.S. Erroneously.

Consequence

The light given off from the daytime running lights is brighter than allowed by U.S. Standards.

Remedy

Dealers will be advised to deactivate the running light function and to complete any outstanding safety recalls on these vehicles.

This recall on nhtsa.gov

Trailer hitches

Summary

Vehicle description: multi-purpose vehicles. The trailer hitch assembly to the frame attaching bolts could lose the clamp load.

Consequence

The trailer hitch could then separate from the vehicle.

Remedy

Dealers will replace the trailer hitch mounting bolts and nut plates.

This recall on nhtsa.gov

Wheels › Lugs/nuts/bolts/studs

Summary

Vehicle description: multi-purpose vehicles and light duty pickup trucks. The lug nuts on these vehicles may not create sufficient clamp load allowing wheel movement in relation to the hub/rotor mounting surface.

Consequence

This can result in the loosening of lug nuts, stud fatigue failure, and the potential for a wheel separation from the vehicle, increasing the risk of a vehicle crash.

Remedy

Owners of these vehicles will be receiving two notifications. The first notification, which began in may 1998, will provide an interim repair procedure until parts become available. This interim procedure can be completed by owners or their dealers. It specifies that the lug nut torque must be verified to be 100 lbs. Then the lug nuts need to be tightened an additional 1/8 to 1/4 turn more. There will be a second owner notification, which is expected to begin July 20, 1998, under which dealers will inspect the wheel studs and replace the wheel lug nuts.

This recall on nhtsa.gov

Power train › Automatic transmission › Gear position indication (prndl)

Summary

Vehicle description: light duty pickup trucks and multi-purpose passenger vehicles. If the automatic transmission shift cable assembly was not fully attached to the steering column bracket, the shift cable assembly can come out of the bracket. The vehicle operator would then not be able to shift the transmission from one of the drive gear positions into the park position even though the gear shift selector would indicate "park."

Consequence

The condition would not allow a disengagement of the transmission from the park position or affect proper neutral start switch operation. Unintended vehicle movement could occur if the parking brake was not set.

Remedy

Dealers will make the proper attachment of the transmission shift control cable to the steering column bracket and add a tie strap to that connection.

This recall on nhtsa.gov

Suspension › Rear

Summary

The rear axle track bar bracket can separate from the frame due to missing welds or inadequate weld penetration.

Consequence

If both brackets separate, the rear axle can move laterally until the tires contact either the frame or the wheelhouse resulting in either tire damage or a significant reduction in vehicle handling performance.

Remedy

Dealers will install a track bar bracket reinforcement kit and inspection of the axle tubes. The suspect axle tubes do not have a stamped date code on the tube. Axles without date codes on the tubes will be replaced.

This recall on nhtsa.gov