Skip to content
AnyRecalls

1998 Kenworth T600 recalls

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

4 recalls found in NHTSA data as of September 22, 2026

For the 1998 Kenworth T600. These apply to the model and year, not to one particular vehicle: check your VIN to see whether yours is included and whether it has been repaired.

Has your Kenworth been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Kenworth dealer can also check your VIN. Recall repairs are free.

1998 Kenworth T600 recalls, newest first

April 1, 2003NHTSA 03V125000154 vehicles potentially affected

Suspension › Front › Hub

Summary
On certain trucks equipped with truck hub units manufactured by skf exclusively for use on arvinmeritor's FF98X series non-drive steer axles, the hub unit bearings can wear prematurely.
Consequence
Seizure of the bearings can cause wheel separation or wheel end fire.
Remedy
Dealers will replace all front axle hubs. Notification began July 16, 2003. The manufacturer has advised us that parts will not be available until September 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy with a reasonable time should contact peterbilt at 940-591-4201 or kenworth 425-828-5440.

This recall on nhtsa.gov

February 20, 2001NHTSA 01V051000209 vehicles potentially affected

Suspension › Front › Control arm › Lower arm

Summary
Vehicle description: vehicles equipped with 54" rear axle spacing configuration of the airglide 200 suspension with the service application identified as logger, dump truck, or tanker. The rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint.
Consequence
Failure of the lower sway arm attaching bolts could result in loss of vehicle control.
Remedy
Dealers will replace the lower sway arm brackets. Owner notification began March 27, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5000.

This recall on nhtsa.gov

July 9, 1999NHTSA 99V181001272 vehicles potentially affected

Electrical system › Ignition › Module

Summary
Vehicle description: heavy duty trucks equipped with caterpillar engines and eaton autoshift transmissions. The engines can stall because of software problems.
Consequence
Increased steering effort can occur.
Remedy
Dealers will update these engines with software changes. Caterpillar is conducting the owner notification and remedy of this recall.

This recall on nhtsa.gov

June 11, 1998NHTSA 98V1290009,500 vehicles potentially affected

Electrical system › Wiring › Front underhood

Summary
Vehicle description: heavy duty trucks equipped with caterpillar 3406E engines. The routing of the electrical and fuel lines can cause chaffing of the wiring harness on the fuel line.
Consequence
This chaffing can cause fuel leakage and a potential for a fire in the engine compartment.
Remedy
Dealers will inspect, adjust, and repair, if necessary, the fuel line and electrical harness.

This recall on nhtsa.gov

Owner complaints

No owner complaints about the 1998 Kenworth T600 were found in NHTSA’s complaint data.

Other Kenworth T600 years

Other 1998 Kenworth models

Most recalled 1998 vehicles

  1. 1998 Honda Accord (19 recalls)
  2. 1998 Ford F-150 (18 recalls)
  3. 1998 Honda Civic (18 recalls)
  4. 1998 Dodge Ram (17 recalls)
  5. 1998 Blue Bird TC2000 (17 recalls)
All of 1998’s most recalled vehicles

Questions

Does the 1998 Kenworth T600 have any recalls?
4 recalls found in NHTSA data as of September 22, 2026, covering: suspension, electrical system. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.
How do I check if my 1998 Kenworth T600 recall has been fixed?
Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Kenworth dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.
How many complaints have owners filed about the 1998 Kenworth T600?
0 complaints filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.