1996 Lincoln Town Car recalls

Steering

• Aftermarket equipment: applies only if this part was installed

Summary

Dorman Products, Inc. (Dorman) is recalling certain model Dorman Steering Shafts, part number 425-359, Solutions Steering Shafts, part number 7-0359, and OE Solutions Steering Shafts, part number 425-359, manufactured April 17, 2014, to September 28, 2015. These aftermarket replacement steering shafts are sold for use in 1995-2002 Ford Crown Victoria, Mercury Grand Marquis, and Lincoln Town Car vehicles. These steering shafts may separate during operation if the integral fastener is loose or missing and if the interfacing vehicle shaft is compressed in length.

Consequence

If the shafts separate during vehicle operation, a loss of steering control would result, increasing the risk of a vehicle crash.

Remedy

Dorman will notify owners, and dealers will replace the steering shaft, free of charge. The recall began on October 28, 2015. Owners may contact Dorman customer service at 1-800-523-2492, option 5.

This recall on nhtsa.gov

Vehicle speed control

Summary

On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn.

Consequence

This could result in an underhood fire.

Remedy

Dealers will install a fused wiring harness. Owners of the passenger cars included in this campaign will be instructed to return their vehicles to their dealers to have the speed control deactivation switch disconnected as an interim repair. As soon as repair parts are available (expected October 2007), owners will be instructed to return to the dealers for installation of a fused wiring harness. The recall began on August 13, 2007, and mailing completed by September 19, 2007. Owners may contact Ford at 1-888-222-2751.

This recall on nhtsa.gov

Air bags › Frontal › Driver side › Inflator module

Summary

Equipment description: passenger vehicles that have had the driver's air bag module replaced after April 5, 2000. The replacement driver's air bag module inflator may have insufficient welds that could prevent proper inflation of the air bag.

Consequence

In the event of a crash, the driver's air bag may not properly deploy which could potentially result in less than the intended level of occupant protection.

Remedy

Dealers will inspect and, if necessary, replace the driver's air bag module. Owner notification began October 5, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Ford at 1-866-436-7332.

This recall on nhtsa.gov

Seat belts › Front › Anchorage

Summary

Vehicle description: passenger vehicles using aftermarket front passenger side seat belt assemblies that were sold by Ford parts departments from January 1, through June 13, 2000. These seat belt assemblies fail to comply with the requirements of FMVSS no. 209, "seat belt assemblies." the equipment involved is service stock seat belt assemblies, model nos. H 9977, h 9979, t 9063, and t 9217, built by TRW vehicle safety systems, Inc. (TRW) manufactured from June 1, 1998 through may 21, 2000. Some of these seat belt assemblies may have been installed as service replacement equipment on the vehicles involved in the recall.

Consequence

In the event of a collision, these seat belts may not restrain an occupant increasing the risk of injury.

Remedy

Dealers will inspect these vehicles and replace the service seat belt assemblies that were installed in these vehicles from January 1 through June 13, 2000.

This recall on nhtsa.gov

Seat belts › Front › Anchorage

Summary

Vehicle description: passenger vehicles using aftermarket driver's seat belt assemblies that were sold by Ford parts departments from January 1, through June 13, 2000. These seat belt assemblies fail to comply with the requirements of FMVSS no. 209, "seat belt assemblies." the equipment involved is service stock seat belt assemblies, model nos. H 9977, h 9979, t 9063, and t 9217, built by TRW vehicle safety systems, Inc. (TRW) manufactured from June 1, 1998 through may 21, 2000. Some of these seat belt assemblies may have been installed as service replacement equipment on the vehicles involved in the recall.

Consequence

In the event of a collision, these seat belts may not restrain an occupant increasing the risk of injury.

Remedy

Dealers will inspect these vehicles and replace the service seat belt assemblies that were installed in these vehicles from January 1 through June 13, 2000.

This recall on nhtsa.gov

Suspension › Front › Control arm › Lower ball joint

Summary

Vehicle description: certain 1996-1999 Ford crown victoria police, fleet, natural gas, and 1996-1999 Lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 Ford crown victoria police, fleet, and ngv vehicles and 1990-1996 Lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. The one-piece bearing within the lower control arm ball joint can weaken slowly during use and eventually crack. This could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.

Consequence

If this occurs while the vehicle is moving, reduced steering control could occur, increasing the risk of a crash.

Remedy

Dealers will replace the lower control arm ball joints (2).

This recall on nhtsa.gov

Steering › Linkages

Summary

The pitman arms were not fully lubricated at the assembly plant. The "ball joint" at the outer end of the pitman arm can become contaminated and corrode.

Consequence

Such corrosion can result in abnormal wear of the joint, resulting in separation of the joint. Loss of steering control can occur increasing the risk of a vehicle accident.

Remedy

Dealers will inspect the vehicles and if the joint is found to have significant wear, the arm will be replaced. Those pitman arms not replaced will have the "ball joint" fully greased.

This recall on nhtsa.gov

Seat belts › Rear/other

Summary

The elr/alr feature is used to accommodate child restraints. When servicing the rear belt assemblies, wrong parts could have been used which do not contain the automatic locking feature.

Consequence

In the event of an accident, the seat belt assemblies may not properly secure the child restraint increasing the risk of personal injury to the seat occupant.

Remedy

Dealers will replace the rear belt assemblies with the appropriate design retractor and tongue assemblies.

This recall on nhtsa.gov

Latches/locks/linkages › Doors › Latch

Summary

When in the secondary latched position, the driver door latches may open when subjected to transverse loads less than that specified in FMVSS no. 206, "door locks and door retention components."

Consequence

The driver's door, when closed only to the secondary latched position, may not sustain a 1,000 pound transverse load.

Remedy

Dealers will inspect and, if necessary, replace the driver door latch.

This recall on nhtsa.gov