Skip to content
AnyRecalls

1991 Plymouth Voyager recalls

Source: NHTSA data as of September 22, 2026. Last refreshed Sep 23, 2026, 2:43 AM UTC.

8 recalls found in NHTSA data as of September 22, 2026

For the 1991 Plymouth Voyager. These apply to the model and year, not to one particular vehicle: check your VIN to see whether yours is included and whether it has been repaired.

Has your Plymouth been repaired?

Recalls here come from NHTSA’s records for the model and year. Not every vehicle of a model is included in every recall, and this site can’t see whether a repair has been done. Only a VIN lookup can tell you that.

NHTSA’s VIN search doesn’t show recalls that were already repaired, recalls more than 15 years old, or some small manufacturers’ recalls. A Plymouth dealer can also check your VIN. Recall repairs are free.

1991 Plymouth Voyager recalls, newest first

September 2, 1999NHTSA 99V2130001,318,189 vehicles potentially affected

Structure › Body › Hatchback/liftgate › Hinge and attachments

Summary
Vehicle description: mini vans. The bolts used to attach the strut to the body and the rear liftgate can accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing cycles is higher than for the average customer, the bolt can fail.
Consequence
Personal injury could occur if the bolts break allowing the liftgate to fall suddenly.
Remedy
Dealers will inspect for loose fasteners, if the fasteners are loose, the strut (and integral bolts) will be replaced. If the bolt shows evidence of torque, the bolt will be removed, larger washers will replace the existing washer and the bolt will be reinstalled and hand tightened to the target torqued.

This recall on nhtsa.gov

July 16, 1999NHTSA 99V189000828,559 vehicles potentially affected

Visibility › Windshield wiper/washer › Linkages

Summary
Vehicle description: minivans. The left hand windshield wiper pivot drive arm was not mechanically staked to the pivot shaft.
Consequence
This could allow the drive arm to disengage from the shaft leading to a loss of wiper function. The driver's visibility would be impaired, increasing the risk of a crash.
Remedy
Dealers will replace the left hand side windshield wiper pivot assembly.

This recall on nhtsa.gov

September 9, 1997NHTSA 97V1490001,100,000 vehicles potentially affected

Seat belts › Front › Anchorage

Summary
Vehicle description: passenger mini-vans. The center rear seat, right outboard side, safety belt anchor hook can become unattached from the body anchor position.
Consequence
In the event of a vehicle crash, the occupant may not be properly restrained increasing the risk of personal injury.
Remedy
Dealers will replace the anchor hook retaining clip with a revised profile clip and a cover plate.

This recall on nhtsa.gov

September 9, 1997NHTSA 97V1480001,100,000 vehicles potentially affected

Seat belts › Front › Buckle assembly

Summary
Vehicle description: passenger mini-vans. Covers on the solid stalk mounted seat belt buckles can become dislodged causing the release button to stick inside the cover. The buckle would then be only partially latched.
Consequence
In the event of a vehicle crash, the occupant may not be properly restrained increasing the risk of personal injury.
Remedy
Dealers will install a cover retaining clip to the stalk mounted buckle cover to prevent dislocation of the buckle cover.

This recall on nhtsa.gov

November 18, 1996NHTSA 96V229000675,000 vehicles potentially affected

Steering › Steering wheel/handle bar

Summary
The steering wheel armature stamping can crack and separate from the center hub attachment to the steering column.
Consequence
If the steering wheel separates from the center hub attachment to the steering column, loss of control can occur increasing the risk of an accident.
Remedy
Dealers will inspect the steering wheel for armature cracks in the center hub attachment area. Any steering wheels showing cracks will be replaced. All other vehicles will have a reinforcement plate installed to prevent steering wheel separation in the event cracking occurs.

This recall on nhtsa.gov

June 13, 1996NHTSA 96V099000321,000 vehicles potentially affected

Service brakes, hydraulic › Antilock/traction control/electronic limited slip

Summary
The ABS hydraulic control unit can experience excessive brake actuator piston seal wear causing pump-motor deterioration.
Consequence
If this condition occurs, the ABS function could be lost and reduced power assist would be experienced during vehicle braking increasing the potential for a vehicle accident.
Remedy
Dealers will test the vehicle's anti-lock brake system and repair the vehicles if necessary. Also the warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will also be reimbursed for previous ABS component repair costs.

This recall on nhtsa.gov

March 10, 1992NHTSA 92V03000010,492 vehicles potentially affected

Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings

Summary
The anti-lock brake system high pressure pump may be porous which will result in brake fluid leakage.
Consequence
Fluid leakage eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure pump and high pressure hose if the last six digits of the bar code label on the pump are between 052300 and 059262.

This recall on nhtsa.gov

November 1, 1991NHTSA 91V19100080,000 vehicles potentially affected

Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings

Summary
The anti-lock brake system high pressure hose may leak or detach at its crimped end fitting resulting in the discharge of hydraulic fluid.
Consequence
Fluid discharge eventually causes the loss of both theanti-lock brake system and hydraulic assist for the brake system, resulting inincreased likelihood of brake lockup and increased stopping distances, whichcould result in a vehicle accident.
Remedy
Replace the ABS high pressure hose with a hose of different design and construction.

This recall on nhtsa.gov

Owner complaints

Owners have filed 520 complaints about the 1991 Plymouth Voyager with NHTSA. Complaints are unverified reports from the public; NHTSA uses them to decide what to investigate.

Crashes reported
26
Fires reported
7
Injuries reported
28
Deaths reported
3

Most complained-about components

  1. Service brakes157
  2. Hydraulic › Antilock/traction control/electronic limited slip116
  3. Seat belts › Front › Anchorage53
  4. Power train › Automatic transmission35
  5. Seat belts › Front › Buckle assembly28

Other Plymouth Voyager years

Other 1991 Plymouth models

Most recalled 1991 vehicles

  1. 1991 Honda Accord (13 recalls)
  2. 1991 Blue Bird TC2000 (12 recalls)
  3. 1991 Acura Integra (11 recalls)
  4. 1991 Thomas School Bus (11 recalls)
  5. 1991 Chevrolet Caprice (10 recalls)
All of 1991’s most recalled vehicles

Questions

Does the 1991 Plymouth Voyager have any recalls?
8 recalls found in NHTSA data as of September 22, 2026, covering: structure, visibility, seat belts, steering, service brakes, hydraulic. Recalls apply to the model and year; whether a particular vehicle is included, and whether it has been repaired, depends on its VIN.
How do I check if my 1991 Plymouth Voyager recall has been fixed?
Enter your 17-character VIN at nhtsa.gov/recalls, or ask a Plymouth dealer. Recall repairs are free. NHTSA's VIN search doesn't list recalls that were already repaired.
How many complaints have owners filed about the 1991 Plymouth Voyager?
520 complaints filed with NHTSA. Complaints are unverified reports from the public that NHTSA uses to decide what to investigate.