1995 Chevrolet Cavalier recalls

Exterior lighting › Headlights

• Aftermarket equipment: applies only if this part was installed

Summary

Dope, Inc. Is recalling 42,540 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.

Consequence

Decreased lighting visibility may result in a vehicle crash.

Remedy

Dope, Inc. Will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on July 28, 2009. Owners may contact dope, Inc. At 1-626-272-1798.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Sabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.

Consequence

Decreased lighting visibility may result in a vehicle crash.

Remedy

Sabersport will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on may 11, 2009. Owners may contact sabersport at 1-909-598-7589.

This recall on nhtsa.gov

Steering

• Aftermarket equipment: applies only if this part was installed

Summary

Dorman products is recalling 3,900 intermediate steering shafts dorman part nos. 425-151, 425-152, and 425-153, (sold under dorman's "oe solutions" brand name), balkamp #'s 7-3057, 7-3058, 7-3059 (sold under the "napa" brand name), and platinum parts #'s 2425151, 2425152, and 2425153 manufactured during the month of September 2007. These replacement steering shafts can be used on the vehicles listed above. The weld connecting the inner tube to the outer tube may be defective.

Consequence

If the weld fails, loss of steering could result, possibly resulting in a vehicle crash.

Remedy

Dorman will notify owners and replace the steering shafts free of charge. The recall began on October 16, 2008. Owners may contact dorman toll free at 1-800-523-2492.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Certain ck motorsports combination headlights, clear corner, bumper, and side marker lights sold as replacement lamps for use on the passenger vehicles listed above. Some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

Consequence

Without the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash without warning.

Remedy

Ck motorsport will notify owners and replace the noncompliant lamps free of charge. The recall began on July 1, 2006. Owners may contact ck motorsport at 1-909-610-7211.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Certain pro-a motors corner lamps, turn signals, and headlights sold as replacement lamps for use on certain passenger vehicles listed above. Some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

Consequence

Without the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash without warning.

Remedy

Pro-a motors will notify owners and offer to repurchase the lamps. The recall began on April 3, 2006. Owners may contact pro-a motors at 323-838-2988.

This recall on nhtsa.gov

Electrical system › Ignition › Switch

Summary

On certain passenger vehicles. If the engine fails to start and the driver holds the key in the "start" position for an extended period, high current flows through the ignition switch, and sometimes produces enough heat to melt internal switch parts.

Consequence

If the switch is damaged, a fire could occur in the steering column, even with the engine off and the key removed.

Remedy

Dealers will install a relay kit in these vehicles to prevent high current from flowing through the ignition switch. Owner notification began March 27, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Chevrolet at 1-800-222-1020, Pontiac at 1-800-762-2737, Buick at 1-800-521-7300, or Oldsmobile at 1-800-442-6537.

This recall on nhtsa.gov

Exterior lighting › Hazard flashing warning lights

Summary

The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with FMVSS no. 108, "lamps, reflective devices, and associated equipment."

Consequence

If these lamps were not flashing, other vehicles would not be aware that this vehicle was stopped increasing the risk of an accident.

Remedy

Dealers or vehicle owners will inspect for proper function of the hazard warning lamps. If necessary, dealers will replace the hazard lamp switch.

This recall on nhtsa.gov

Structure › Frame and members

Summary

Some welds were omitted from the body lock pillar, or "b" pillar. This does not comply with FMVSS NO.208, "occupant crash protection."

Consequence

Consequence of non-compliance: if a vehicle crash should occur, occupant protection levels could be reduced.

Remedy

All vehicles in this recall campaign have been repurchased and replaced with a comparable vehicle.

This recall on nhtsa.gov

Suspension › Front › Control arm › Lower arm

Summary

These vehicles have been built with welds missing from the front suspension lower control arm assemblies causing excessive loads on the existing welds.

Consequence

This condition can result in separation of the frontbushing sleeve subassembly from the control arm increasing the potential for a vehicle crash.

Remedy

Dealers will inspect both left-hand and right-hand front suspension lower control arm assemblies and replace all control arm assemblies found with omitted welds.

This recall on nhtsa.gov