1995 Chevrolet Blazer recalls

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Sabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.

Consequence

Decreased lighting visibility may result in a vehicle crash.

Remedy

Sabersport will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on may 11, 2009. Owners may contact sabersport at 1-909-598-7589.

This recall on nhtsa.gov

Fuel system, gasoline

• Aftermarket equipment: applies only if this part was installed

Summary

Certain replacement fuel filters, fram brand name p/n G3727, with date codes X52911 through X60801 sequentially or X600141 and a mexico country or origin marking on the fuel filter housing manufactured from October 18, 2005, through March 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on "document search" and then "bus applications"). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.

Consequence

This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.

Remedy

Honeywell will notify owners and replace the fuel filters free of charge. The recall began on October 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).

This recall on nhtsa.gov

Fuel system, gasoline › Delivery › Hoses, lines/piping, and fittings

• Aftermarket equipment: applies only if this part was installed

Summary

Certain r&b, Inc. Central multiport fuel injection (cmfi) fuel return lines, models help 55163, napa balkamp 700-3270, and the connection 2560001, sold for use as replacement equipment for the vehicles listed above. The fuel return line has a mechanical bleed valve which was not installed at the proper torque.

Consequence

A fuel leak can occur at the valve, possibly resulting in a fire.

Remedy

R&b, Inc. Will notify owners and at the customers request, either replace the fuel line or offer a full refund. The recall began on may 4, 2006. Owners may contact r&b, Inc. At 215-712-5330.

This recall on nhtsa.gov

Exterior lighting › Headlights

• Aftermarket equipment: applies only if this part was installed

Summary

Certain anzo combination headlamp assemblies sold as replacement lamps for use on certain passenger vehicles. Some combination lamps are not equipped with amber side reflectors which fail to conform to federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment."

Consequence

Without the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash.

Remedy

Anzo will notify owners and replace the headlamps free of charge. The recall began may 9, 2006. Owners may contact anzo USA at 909-468-3688.

This recall on nhtsa.gov

Service brakes, hydraulic › Antilock/traction control/electronic limited slip

Summary

Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from September 1989 through August 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive can malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.

Consequence

If this occurred at a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.

Remedy

Dealers will replace or repair the 4-wheel/2-wheel drive switch.

This recall on nhtsa.gov

Visibility › Windshield wiper/washer

Summary

Vehicle description: light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector can crack causing the windshield wipers to work intermittently.

Consequence

This condition can result in inoperative wipers, reducing a driver's visibility, and increasing the risk of a vehicle crash.

Remedy

Dealers will replace the wiper motor circuit board and cover.

This recall on nhtsa.gov

Fuel system, gasoline › Storage › Tank assembly

Summary

Vehicle description: 4-door, 4-wheel drive and all-wheel drive multi-purpose passenger vehicles. During development testing, the prop shaft contacted the inboard side of the fuel tank allowing fuel leakage. This leakage was in excess of the amount permitted by FMVSS 301, "fuel system integrity."

Consequence

If an ignition source is present, and there is a fuel leak, a fire could occur.

Remedy

Dealers will install additional shielding of the fuel tank. This will be added without removing or disassembling the fuel system.

This recall on nhtsa.gov

Engine and engine cooling › Cooling system › Fan

Summary

Fan blade rivet breakage can occur causing the fan blade to separate from the spider.

Consequence

If this occurred while the hood was open, a person working under the hood of the vehicle or in the vicinity of the vehicle could be struck by the fan blade and injured.

Remedy

Dealers will inspect and replace, if necessary, the fan with a newer fan having thicker-headed rivets.

This recall on nhtsa.gov

Suspension › Front › Control arm › Upper ball joint

Summary

The upper ball joint nuts were under-torqued resulting in improper seating in the steering knuckle.

Consequence

This condition can cause the ball joint stud to loosen, and fracture resulting in a loss of steering control.

Remedy

Dealers will retorque the upper ball joint nut on both sides of the vehicle to the correct torque values.

This recall on nhtsa.gov

Service brakes, hydraulic › Pedals and linkages

Summary

The brake pedal pivot bolt was started in the weld nut, but was not torqued correctly causing the bolt to disengage from the weld nut.

Consequence

This condition can result in a total loss of brakingcapability.

Remedy

Dealers will inspect for hand-started brake pedal bolts and torque them to correct specifications.

This recall on nhtsa.gov