1991 Chevrolet S10 recalls

Exterior lighting › Headlights

• Aftermarket equipment: applies only if this part was installed

Summary

K2 motor is recalling 1,921 aftermarket headlamps of various models sold for use on the above listed vehicles. These headlamps are missing the amber side reflex reflector which fails to conform with the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment."

Consequence

Without the amber side reflex reflectors, the lighting visibility may be affected, possibly resulting in a vehicle crash.

Remedy

K2 motor will notify owners and offer a full refund. The recall began on decemeber 17, 2008. Owners may contact K2 motor at 1-909-839-2992.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Certain ck motorsports combination headlights, clear corner, bumper, and side marker lights sold as replacement lamps for use on the passenger vehicles listed above. Some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

Consequence

Without the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash without warning.

Remedy

Ck motorsport will notify owners and replace the noncompliant lamps free of charge. The recall began on July 1, 2006. Owners may contact ck motorsport at 1-909-610-7211.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Certain pro-a motors corner lamps, turn signals, and headlights sold as replacement lamps for use on certain passenger vehicles listed above. Some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

Consequence

Without the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash without warning.

Remedy

Pro-a motors will notify owners and offer to repurchase the lamps. The recall began on April 3, 2006. Owners may contact pro-a motors at 323-838-2988.

This recall on nhtsa.gov

Service brakes, hydraulic › Antilock/traction control/electronic limited slip

Summary

Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from September 1989 through August 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive can malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.

Consequence

If this occurred at a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.

Remedy

Dealers will replace or repair the 4-wheel/2-wheel drive switch.

This recall on nhtsa.gov

Steering › Gear box › Shaft sector

Summary

The intermediate steering shaft loosens at the steering shaft to steering gear coupling. With this looseness, the yoke pinch bolt can wear on the splines of the shaft until there is no longer an interference between the splines and the bolt.

Consequence

This condition can cause body to chassis movement allowing the steering shaft to separate from the steering gear which can result in a loss of steering control.

Remedy

Dealers will retorque the upper and lower bolts to correct specifications.

This recall on nhtsa.gov

Engine and engine cooling › Cooling system › Fan

Summary

The engine cooling fan blades break as a result of fatigue and/or vehicle induced stress.

Consequence

If the blade breakage occurs while the hood is open, aperson working under the hood or in the vicinity of the vehicle could be struckand injured by the blade segment.

Remedy

Install a newly designed fan assembly.

This recall on nhtsa.gov

Fuel system, gasoline › Storage

Summary

Vehicles have been shipped with the fuel tank sender seal out of position.

Consequence

In the event of rollover accident, an out of postionseal could allow fuel spillage in excess of the amount prescribed by FMVSS 301.SPILLED fuel could ignite near an ignition source.

Remedy

Replace sender seals.

This recall on nhtsa.gov

Suspension › Front › Control arm › Lower arm

Summary

Nuts used to attach lower control arms, rear spring and shackle, and rear shock absorbers do not meet specifications and could "strip".

Consequence

Stripping of the nuts in the rear suspension could reduceclamp load on lower control arm, which could allow the arm to detach, resultingin loss of vehicle control and an accident.

Remedy

Replace lower control arm attachment nuts as well as rear spring and shackle, and rear shock absorber nuts.

This recall on nhtsa.gov

Visibility › Windshield

Summary

Use of improper primer on metal surfaces of windshield and side window openings could cause low adhesion to the metal surface and would not provide retention required by FMVSS 212.

Consequence

Windshield and side window glass would not prevent theejection of vehicle occupants during a vehicle crash, which causes seriousinjuries and fatalities.

Remedy

Remove and reinstall glass using proper primer.

This recall on nhtsa.gov