1997 Dodge Dakota recalls

Exterior lighting › Headlights

• Aftermarket equipment: applies only if this part was installed

Summary

Dope, Inc. Is recalling 42,540 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.

Consequence

Decreased lighting visibility may result in a vehicle crash.

Remedy

Dope, Inc. Will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on July 28, 2009. Owners may contact dope, Inc. At 1-626-272-1798.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Sabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." these lamps do not contain the required amber side reflectors.

Consequence

Decreased lighting visibility may result in a vehicle crash.

Remedy

Sabersport will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on may 11, 2009. Owners may contact sabersport at 1-909-598-7589.

This recall on nhtsa.gov

Suspension › Front › Hub

• Aftermarket equipment: applies only if this part was installed

Summary

Skf is recalling 2,805 hub units, part no. BR930361, sold as a service part for 1997-2004 Dodge dakota vehicles and 1999-2003 Dodge durango vehicles equipped with 2-wheel drive & rear axle ABS. Due to a specification error, the rotor pilot for the hub unit may be too long. This results in the wheel to not be seated fully against the hub flange face during mounting.

Consequence

Improper seating of the wheel can result in excessive vibration, brake rotor noise, difficulty removing the wheel after installation and operation of the vehicle, and possibly wheel-end separation during vehicle operation. Should wheel-end separation occur, the driver could loose control of the vehicle, possibly resulting in a crash.

Remedy

Skf will notify owners and replace the defective hub units free of charge. The recall began on November 5, 2008. Owners may contact skf vsm north america customer service at 1-800-644-8999.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Certain aj motorsport combination lamps sold as replacement lamps for use on the above listed passenger vehicles. Combination lamps not equipped with amber side reflectors fail to conform with the requirements of federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

Consequence

Lack of amber side reflectors in the lamps will decrease lighting visibility to other drivers and may possibly result in a vehicle crash.

Remedy

Aj motorsport will notify owners and offer reimbursement for the lamps. The recall began on July 31, 2006. Owners may contact aj motorsport at 626-618-2026.

This recall on nhtsa.gov

Exterior lighting

• Aftermarket equipment: applies only if this part was installed

Summary

Certain pro-a motors corner lamps, turn signals, and headlights sold as replacement lamps for use on certain passenger vehicles listed above. Some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

Consequence

Without the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash without warning.

Remedy

Pro-a motors will notify owners and offer to repurchase the lamps. The recall began on April 3, 2006. Owners may contact pro-a motors at 323-838-2988.

This recall on nhtsa.gov

Engine and engine cooling

• Aftermarket equipment: applies only if this part was installed

Summary

Certain replacement k&n fuel performance kits, p/nos. 57-1509, 57-1511, 57-1511-1, 57-1517, 57-1517-1, 57-1527, and 57-1530. Also, a small percentage of these kits were sold under the mopar performance parts brand name (p/nos. P5007069 and P5007070). All kits were manufactured from April 20, 1999, through September 23, 2004. These assemblies were manufactured as replacement equipment for certain Dodge pickup trucks and SUVS. A small piece of material from the tube wall could be sucked into the engine throttle body, which could cause the throttle to become jammed in the open position.

Consequence

A jammed open throttle could cause unintended acceleration of the vehicle, possibly resulting in a crash or increased stoping distances when braking.

Remedy

K&n will provide owners with a free repair kit along with repair instructions. The recall began on April 20, 2006.

This recall on nhtsa.gov

Service brakes, hydraulic

• Aftermarket equipment: applies only if this part was installed

Summary

Certain aftermarket brake hydraulic master cylinders sold as replacement brake cylinders for certain Ford, daimlerchrysler, and Jeep passenger vehicles. These brake cylinders were sold under the brand names of napa, raybestos, aimco, AC delco, carquest, bendix, and wagner. Only products that were manufactured from July 27, 2005 through January 17, 2006 (date codes 0529 through 0602) are subject to this recall. When subject to very cold temperatures, an internal seal in the master cylinder could lose flexibility and may cause brake fluid to leak.

Consequence

Loss of brake fluid can lead to a decrease in brake line pressure and an increase in stopping distance, which can result in a vehicle crash.

Remedy

Affinia (brake parts, Inc.) will replace the subject brake hydraulic master cylinders free of charge. The recall began on March 20, 2006. Owners can contact affina group customer service at 1-800-323-0354.

This recall on nhtsa.gov

Air bags

Summary

Vehicle description: pickup trucks. Sound deadener material inside the steering wheel could become detached from the cover and housing. Note: the ram pickup trucks were built at the warren assembly plant ("s" in the 11th VIN position) from may 16, 2000 through October 23, 2000; st. Louis north assembly plant ("j" in the 11th VIN position) from may 19, 2000 through October 23, 2000; lago alberto assembly plant ("m" in the 11th VIN position) from may 23, 2000 through October 23, 2000; and saltillo assembly plant ("g" in the 11th VIN position) from may 23, 2000 through October 23, 2000. Important: vehicles that have already had the proper clockspring installed, according to warranty records, have been excluded from this recall. In addition, 1997-2000 model year vehicles that have had a suspect replacement clockspring installed, according to warranty records, have been added to this recall.

Consequence

When this occurs, the material could interfere with the clockspring ribbon and cause an open circuit. The driver air bag system will become disabled, and the air bag warning lamp will illuminate on the instrument panel.

Remedy

Dealers will replace the clockspring assembly. Owner notification began June 18, 2001. Also some 1997-200 model year vehicles that, according to warranty records, have had a suspect replacement clockspring installed, will also be included in this campaign. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler at 1-800-853-1403.

This recall on nhtsa.gov

Fuel system, gasoline › Delivery › Hoses, lines/piping, and fittings

Summary

Vehicle description: pickup trucks with a 131 inch wheelbase. Some of these vehicles may have been built with inadequate clearance between the fuel line and the cab underbody.

Consequence

This contact can result in wear, and after extended contact, could cause a perforation in the fuel line, resulting in leakage. Fuel leakage in the presence of an ignition source could result in a fire.

Remedy

Dealers will inspect the vehicles for proper clearance. Fuel lines that exhibit inadequate clearance will be replaced with a redesigned fuel line that will assure proper clearance.

This recall on nhtsa.gov

Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings

Summary

Vehicle description: pickup trucks. Some vehicles may have been built with inadequate clearance between the rear axle vent hose and the brake hose.

Consequence

A puncture in the rear brake hose will result in a loss of braking force at the rear wheels.

Remedy

Dealers will inspect the rear brake hose for evidence of wear. Worn brake hoses will be replaced. The rear vent hose will be shortened by 3 inches and a clip will be installed to assure clearance between the axle vent line and brake hose is maintained.

This recall on nhtsa.gov

Service brakes, hydraulic › Foundation components › Hoses, lines/piping, and fittings

Summary

Vehicle description: pickup trucks built with 2.5L engines. Some vehicles may have been built with inadequate clearance between the left front brake tube and the power steering hose.

Consequence

A puncture of the left front brake tube can result in a loss of braking force at the front wheels, increasing the risk of a crash.

Remedy

Dealers will inspect the brake tube and power steering hose for wear. If wear is evident, the brake tube and/or power steering hose will be replaced. A power steering standoff bracket will be installed on all vehicles to ensure that adequate clearance between the brake tube and power steering hose is maintained.

This recall on nhtsa.gov

Air bags › Frontal › Sensor/control module-inactive

Summary

The electrical circuit design allows the potential for an inadvertent air bag deployment upon vehicle ignition shut down.

Consequence

Unexpected air bag deployment can result in occupant injury.

Remedy

Dealers will replace the air bag electronic control module with a newly designed module.

This recall on nhtsa.gov