1988 Ford Taurus recalls

Structure › Frame and members

Summary

Vehicle description: passenger vehicles originally sold or currently registered in connecticut, delaware, district of columbia, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, nebraska, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, virginia, west virgnia, and wisconsin. The rear lower subframe mount plate nut can experience stress corrosion cracking if subjected to long term exposure to road salts. This can result in fracture and loss of the structural integrity of the subframe mount attachment. Detachment of the body mounts at the rear corners of the subframe, which supports the engine and transmission, allows the rear corners of the subframe to drop.

Consequence

If both rear corners drop, steering would become suddenly very difficult, affecting vehicle control and increasing the risk of a crash.

Remedy

Dealers will install subframe rear mount bolts, reinforcement plates, and plate nuts.

This recall on nhtsa.gov

Suspension › Front › Shock absorber

• Aftermarket equipment: applies only if this part was installed

Summary

The arc welds on the sway bar bracket, where it attaches to the strut reserve tube, did not fuse properly.

Consequence

Over time, a portion of the bracket can tear away from the strut, falling into and puncturing the tire or causing damage to the wheel, which could result in an accident.

Remedy

Monroe dealers will replace the strut free of charge.

This recall on nhtsa.gov

Structure › Frame and members

Summary

Vehicle description: taurus and sables built from 10-14-85 through 8-19-88, and Lincoln continentals built from 11-4-87 through 9-30-88 (except 1989 - 1991 2.5L taurus and 1989 - 1992 sho). The affected cars were originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, and wisconsin. The body mounts at the rear corners of the subframe, which supports the engine and transmission, may become detached due to corrosion of the subframe mount retaining plate. This would allow the rear corners of the subframe to drop.

Consequence

If one of the rear corners drops, only minor indications of a malfunction such as a clunking noise or slight change in steering wheel alignment are noticeable. However, if both rear corners of the subframe drop, steering becomes very difficult, which could adversely affect vehicle control and possibly result in an accident.

Remedy

Install a corrosion-resistant reinforcing plate and a new bolt on both rear subframe mounts. This recall campaign has been superseded by recall 98V-323.

This recall on nhtsa.gov

Wheels

Summary

Children can accidentally lock themselves in the footwell area of the rear-facing third seat, or in the storage compartment in station wagons not equipped with an optional third seat. Once the compartment is closed it cannot be opened from the inside.

Consequence

There is a danger of air deprivation, hyperthermia,and/or panic response to a child who has locked himself or herself into thecompartment, with the possibility of asphyxiation.

Remedy

Replace the self-latching assembly currently used in the rear storage compartment with a latch assembly that can only be closed with a key.

This recall on nhtsa.gov

Service brakes, hydraulic › Foundation components › Disc › Rotor

Summary

Front disc brake rotors of the subject vehicles may experience severe corrosion if operated in areas where calcium chloride and sodium chloride are used extensively.

Consequence

Severely corroded rotors may fracture or separate nearthe inner edges of the brake discs resulting in reduced braking effectiveness,higher than normal pedal efforts, loud grinding noises, and moderate pulls whenthe brakes are applied. Reduced braking effectiveness may increase minimumstopping distances, possibly resulting in an accident.

Remedy

Replace front brake rotors with full cast front brake rotors.

This recall on nhtsa.gov

Seats

Summary

The power seat switch wiring is routed over rather than under the front seat support brace, allowing damage by seat cushion spring ends when seat is occupied.

Consequence

Power seat switch wiring insulation may become abraded,or punctured, and an electrical short could occur that could result in a firein the seat cushion material.

Remedy

Revise routing of power seat wiring to prevent damage from seat cushion spring contact.

This recall on nhtsa.gov